Instructions for Non-Vacuum Donor Cornea Punch

When the punch is received it will be in a sterile pouch that is housed in a cardboard carton along with instructions and a marking pen. The punch top and bottom cutting block are separated by a ring that prevents the blade from contacting the block during shipment.
Barron Vacuum Donor Cornea Punch - part detail

The parts are held together with a silicone band.
Barron Vacuum Donor Cornea Bunch - removable shipping band


Suggestions for Use
CAUTION

Before clinical use, the surgeon should thoroughly understand all aspects of the surgical procedure and the use of the Donor Cornea Punch.

The Donor Cornea Punch is packaged in a hermetically-sealed pouch that is gas sterilized with ethylene oxide. It is a disposable unit designed for single-use and should not be resterilized or reused. The Donor Cornea Punch has been carefully checked before packaging and is ready for use when it is received.

The Barron Donor Cornea Punch should be used only by a licensed physician who is familiar with corneal transplant surgery and with the use of this instrument. The following instructions do not include all of the procedural steps required to perform corneal transplant surgery.

Barron Vacuum Donor Cornea Punch size numbers
Punch Size Numbers
1. The size of the punch blade is stamped on both the top of the punch top and the side of the cutting block as indicated in the photo at the right (the stamped numbers are circled in red). Verify the blade diameter and remove the elastic silicone band from the instrument.

2. While holding the cutting block with one hand, use the other hand to pull the punch top straight upward, turn it over, and place it on a sterile tray. Discard the white blade protector ring that is used to separate the punch top from the cutting block.

Diagram - Barron Vacuum Donor Cornea Punch marking before procedure
Marking punch
3. There are two ways that can be used to mark the 4 quadrants on the epithelial side of the donor cornea. One is to mark the cutting block prior to placing the cornea in the block. Open the sterile pouch that contains the surgical marking pen that comes with the punch assembly, and place the tip of the pen into each of the four holes in the well of the cutting block. Rotate (twist) the pen until the sides of each hole are evenly coated with gentian violet ink.

4. Place the donor cornea in the base with endothelial side facing up. Remove all scleral tissue protruding beyond the cutting block well. Center the graft in the cutting block using a fine- toothed forceps.

5. Place the four guide posts of the punch top into the corresponding corner holes of the cutting block. Press the top down gently until the blade comes into contact with the cornea.

Barron Donor Cornea Punch being seated
6. Place the cutting block on a solid, flat surface. Insert the four steel guide posts of the seating ring housing into the corresponding holes in each corner of the cutting block and press down gently.

Diagram applying pressure with thumb for Vacuum Donor Cornea Punch7. Place the block (with top in place) on a flat surface, place a thumb directly over the center hole of the punch top and press down firmly with enough force to cut through the cornea.

8. Remove the blade by pulling the punch top upward. The corneal button will usually remain in the well of the cutting block, while the peripheral corneoscleral rim remains on the blade. If the button remains in the blade, it may be dislodged by dripping Balanced Salt Solution (BSS) or viscoelastic substance on the endothelial side of the button through the center of the punch blade.


The instructions for the Barron Donor Punch are available in pdf format in English, French, German, Italian, and Spanish.